12:57. Removal and installation of an external mirror and glass of a mirror
External mirror
1 case of a mirror 2 block of adjustment of a mirror (manual). The block of electric adjustment, address the subsection Removal and installation of a door of a back. 3 beam of adjusting elements 4 screw with an internal hexagon, 12 N • m 5 consolidation. At installation check correctness of a prileganiye. | 6 screw with crosswise shliyets, 1 N • m 7 glass of a mirror 8 finger 9 clip |
Block of manual adjustment of a mirror REMOVAL
PERFORMANCE ORDER |
1. Remove an external mirror from a door. | 2. Remove mirror glass. | 3. Disconnect electric wires of heating of a mirror. | 4. Turn out screws with crosswise shliyets –6– and take out the adjusting block from the case. |
|
INSTALLATION
PERFORMANCE ORDER |
It is carried out in the sequence, the return to removal. | |
Mirror glass
REMOVAL
PERFORMANCE ORDER |
1. Paste over the mirror case from above and from below with an adhesive tape. | 2. Carefully wring out glass the pallet at first below, and then above. | |
INSTALLATION
ATTENTION
At mirror glass installation surely use gloves or enclose a pure rag.
PERFORMANCE ORDER |
1. Insert glass into the directing pins, and fingers –8– in clips –9–. | 2. Press mirror glass, having pressed it in the center. | |
Mirror case REMOVAL
ATTENTION The case of a mirror can be removed without removal of a mirror in general.
PERFORMANCE ORDER |
1. Remove glass-7-. |
| 2. Turn out screws-4-. | 3. Press pads –2– and uncover –3– down. | 4. Turn out screws-1-at the block of adjustment of a mirror. | 5. Remove the case-5-up. | |
|
INSTALLATION
PERFORMANCE ORDER |
1. Install the case-5-from above. | 2. Screw screws-1-at the block of adjustment and slightly tighten their moment 1 N • m. |
3. Establish from below a cover –3– and record it. | 4. Establish mirror glass. | |
Block of electric adjustment of a mirror REMOVAL
PERFORMANCE ORDER |
1. Disconnect a negative cable (–) of the rechargeable battery at the switched-off ignition.
ATTENTION Thereof information from electronic blocks of memory, such as, a radio receiver code is erased. Without code the radio receiver can be switched on on HUNDRED AUDIS. Therefore study instructions in the subsection Input of a Code of the Radio Receiver.
| | 2. Remove mirror glass. | 3. Turn out screws-1-. | 4. Rasstykuyte shtekerny connections of the block of adjustment of a mirror.
ATTENTION In the presence of solder connections they need to be disconnected separately directly at the case. Write down an arrangement of accessions before their undocking.
| 5. Take out the adjustment block from the case. | | |
INSTALLATION
PERFORMANCE ORDER |
1. Insert the adjustment block into the case. | 2. Attach electric wires according to their arrangement. | 3. Slightly tighten screws-1 the moment of 1 N • m. | 4. Establish glass. | 5. Attach a cable of mass of the rechargeable battery. ATTENTION
Make active high-rise automatic equipment of the power window, and also establish hours and enter a radio tape recorder code, address the subsection Input of a Code of the Radio Receiver.
| | |