12:31. Removal and installation of loker of an arch of forward and back wheels
Fastening of a loker of an arch of a back wheel
1 – loker of an arch of a wheel 2 – Torx screw, 2 N • m 3 – the nut is nasechny |
4 – channel cover 5 – the directing element |
Loker of an arch переднго wheels REMOVAL
PERFORMANCE ORDER |
1. Remove a forward wheel. ATTENTION Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation get acquainted with Poddomkrachivaniye's subsection of the car. | 2. Mark paint the provision of a forward wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel at the car standing on the earth. Lift a forward part of the car, put it on supports and remove a forward wheel. |
3. Turn out Torx screws. |
|
|
4. Squeeze a loker a little and take out from a wheel arch. | 5. Fix a loker by Torx screws (arrow). | 6. Establish into place a forward wheel so that the markings put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 120 N • m. | |
Loker of an arch of a back wheel REMOVAL
PERFORMANCE ORDER |
1. Remove a back wheel. ATTENTION Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation get acquainted with Poddomkrachivaniye's subsection of the car. | 2. Mark paint the provision of a back wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel at the car standing on the earth. Lift a back part of the car, put it on supports and remove a back wheel. |
3. Turn out Torx-2 screws (shooters). |
4. Squeeze a loker –1– a little and take out from a wheel arch. | |
INSTALLATION
PERFORMANCE ORDER |
1. Squeeze a loker –1– a little and insert into a wheel arch. | 2. Fix a loker by Torx-2 screws (arrow). | 3. you stanovit into place a back wheel so that the markings put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 120 N • m. | |