12:13. Removal and installation of a pocket from the driver

REMOVAL

PERFORMANCE ORDER
1. Disconnect a side cover of the block of safety locks and remove it.
2. Turn out 4 screws of fastening –2–.
3. Turn out 4 screws of fastening –2– (address an accompanying illustration).
4. Raise a side plate of fastening –3– approximately on 1 cm in the direction of an arrow and release.
5. Disconnect a pocket in the points (A) specified illustrations.
6. Rasstykuyte socket of the switch of light and regulator of range of light.
7. Take out a pocket from guides and remove.

INSTALLATION

PERFORMANCE ORDER
1. Establish into place a pocket and push it in guides.
2. Attach the switch of light and the regulator of range of light.
3. Record a pocket in points (And).
4. Establish into place a side plate of fastening –3– and record it.
5. Tighten fastening screws –1 moment of 4 N • m.
6. Tighten fastening screws –2 moment of 4 N • m.
7. Establish into place a cover of the block of safety locks.