12:35. Removal, installation and adjustment of a cowl
Elements of fastening and adjustment of a cowl
1 – cowl 2 – buffer For adjustment of height of a cowl. 3 – gas-filled emphasis 4 – spring 5 - cowl loop | 6 – bolt, 20 N • m 7 – noise muffler Only for diesel engine. 8 – nut, 8 N • m 9 – hook |
REMOVAL
PERFORMANCE ORDER |
1. Open a cowl. |
2. Mark the provision of a cowl. For this purpose lead round a felt-tip pen fastening bolts on loops (from a cowl). |
3. Ask the assistant to support a cowl. ATTENTION At removal of a gas-filled emphasis it is impossible to remove completely a lock spring –4–. Otherwise the emphasis can be damaged and it should be replaced.
| 4. Disconnect a gas-filled emphasis –3– from a cowl. For this purpose raise the screw-driver a lock spring –4– a little. Remove an emphasis from a spherical support. If the emphasis needs to be removed completely, raise the lower spring the same as top and remove the sharovy hinge. |
5. Turn out bolts of fastening –6– on a cowl and remove a cowl by means of the assistant. |
| |
INSTALLATION
PERFORMANCE ORDER |
1. If necessary restore a paint and varnish covering of a cowl. | 2. Establish into place a cowl. Expose a cowl by means of the markings put at removal, and fix by bolts –6–. If the new cowl is established, it needs to be adjusted. | 3. Put an emphasis –3– on a spherical support and record a spring –4–. |
4. If shock-absorbers-2-were removed, they need to be adjusted again. Turn external shock-absorbers for adjustment on height. Screw internal shock-absorbers completely and then turn off on Ѕ a turn. The cowl has to settle down aflush with adjacent details of a body. |
|
Adjustment of a cowl
PERFORMANCE ORDER |
1. Weaken bolts of fastening –6– from a cowl a little so that it could be moved in the longitudinal and cross directions. | | 2. Turn off nuts of fastening of a hook a little (nuts –1–, a hook –2–). |
| 3. Turn off bolts of fastening of the lock of a cowl a little (screws-1-, the lock of a cowl –2–, the holder –3–). | 4. Close a cowl and displace it so that between adjacent elements of a body there was a uniform gap, address Specifications. | 5. Adjust the provision of a cowl on height by turn of external shock-absorbers-2-. | 6. Carefully open the exposed cowl so that not to change the provision of loops of a cowl. |
7. Tighten bolts of fastening of loops the moment of 20 N • m. | 8. Tighten bolts of fastening of the lock of a cowl the moment of 20 N • m. | 9. Tighten nuts of fastening of a hook the moment of 8 N • m. | |