12.65. Replacement of elastic bands of brushes of screen wipers
Brushes of screen wipers at bad quality of purification of glass should be replaced. On sale there are as complete screen wipers (rubber with the holder), and separate brushes. If only rubber is replaced, you watch to bending the holder.
ATTENTION If brushes move, as a rule, not enough to replace with breakthroughs brushes or rubber. Just in case it is necessary to check and if necessary to adjust the angle of installation of levers, at the same time address the subsection Removal and installation, check and adjustment of final position of levers of a screen wiper.
REMOVAL
| PERFORMANCE ORDER |
| 1. Cast away the lever up, put a brush at right angle to the lever. |
| 2. Press a spring clip (A) (the direction of an arrow) and displace a brush (In) from a hook on the lever down. Unhook a brush of the lever. | | 3. Squeeze passatizham both steel tires on the closed party of rubber and take out them from the top bracket. Then take out rubber completely with tires from the remained brush brackets. |
|
INSTALLATION
|
PERFORMANCE ORDER |
| 1. Enclose freely new rubber without tires in the lower brackets of a brush. | | 2. Enter both tires into the first flute of rubber so that grooves of tires showed towards rubber and record in rubber pads of a flute. | | 3. Squeeze both steel tires and rubber of a passatizhama and thus insert into the top bracket that bracket pads in tightening grooves (an arrow on an illustration) rubbers on both sides were recorded. | | 4. Insert rubber via the lever and record spring brackets in lever hooks. If it is available, has to watch a fairing on a brush down. | | 5. Lower the lever back. You watch that rubber adjoined to glass everywhere, otherwise carefully turn in the holder. | |
| |