12:37. Removal and installation of a door of a back

REMOVAL

PERFORMANCE ORDER
1. Remove facing of a door of a back, address the subsection Removal and installation of facing of a door of a back.
2. Rasstykuyte shtekerny connections of heating of back glass and screen wiper. Disconnect a vacuum hose of the uniform lock and a hose of a washer of back glass.
3. Open a door of a back and bring under it a support.
4. Disconnect to top a gas-filled emphasis –2–. For this purpose raise the screw-driver a lock spring –1– a little and remove an emphasis from a spherical support.
5. Mark the provision of a door of a back at a loop –2–. For this purpose a felt-tip pen lead round bolts of fastening of a loop.
6. Turn out bolts of fastening –1– on a door loop (from a loop) at the left and on the right.
7. Remove a door by means of the assistant.

INSTALLATION

PERFORMANCE ORDER
1. Establish by means of the assistant a back door into place.
2. Screw bolts –1–, without tightening them yet.
3. Close a door.
4. Adjust the provision of a door by its movement on earlier put marking. Tighten fastening bolts the moment of 20 N • m. If the new door is established, it is necessary to adjust its situation, address the subsection Adjustment of a Door of a Back.
5. Establish a gas-filled emphasis on a spherical support and record it a lock spring. You monitor its correct provision. Connect an emphasis to a body, address an illustration.
6. Join shtekerny connections of heating of back glass and washer. Put on a vacuum hose of the uniform lock and a hose of windscreen washer.
7. Check operation of the uniform lock and a washer.
8. Establish into place facing of a door of a back, address the subsection Removal and installation of facing of a door of a back.