1.25. Tempostat
By means of a tempostat – within the opportunities determined by engine capacity / efficiency of braking by the engine – it is possible to support any set speed, beginning approximately from 40 km/h. Thanks to it it is not required to hold a leg on an accelerator pedal that is especially convenient at distant trips.Remember that at the movement in mountains physical capacities of a tempostat are limited. At the movement by a setup on roads with strong biases and under certain conditions the car can accelerate over the programmed speed.
ATTENTION
At a speed over 40 km/h and the included tempostat do not switch to neutral transfer without squeezing of a pedal of coupling! Otherwise perhaps sharp increase in turns of the engine that in certain circumstances is fraught with its breakage!
For management tempostaty serve a cursor And yes the button B on the lever switch of indexes of turn and passing beam.
Inclusion
The system joins transfer of a cursor And to position of EIN.
Programming of speed
At achievement of desirable speed press and release the B (FIX) button. The set speed is observed.
Speed can be increased over the programmed value pressing of a pedal of an accelerator. After a pedal otpuskaniye the system will adjust speed with return to earlier programmed size.
It does not belong to cases of excess of the programmed speed on more than 10 km/h over 5 minutes. In this case anew program speed.
Change of speed
Reduction of speed
The established speed can be reduced pressing of the button B.
By each short-term pressing of the button speed decreases by 1.5 km/h. When keeping the button in the pressed situation speed decreases automatically. At an otpuskaniye the current speed is remembered.
At a button otpuskaniye at a speed less than 40 km/h there is a dumping of data of memory of the memory device. In this case, after achievement of speed over 40 km/h, anew program speed by means of the button B.
Increase in speed
The established speed can be increased reduction of a cursor And in position of AUFN without pressing an accelerator pedal.
By each short-term pressing of a cursor speed increases by 1.5 km/h. When keeping a cursor in the pressed situation speed increases automatically. At an otpuskaniye the current speed is remembered.
Temporary shutdown of system
Temporary shutdown of system happens when pressing a pedal of a brake or coupling or at transfer of a cursor And to position of AUS (without fixing).
The speed programmed by this moment remains in memory.
For reproduction (AUFN) of earlier programmed speed transfer a cursor And to extreme left situation, having released a pedal of a brake or coupling.
If at temporary shutdown speed was not programmed, then new speed is established by a cursor And in the following order:
On cars with the petrol engine quickly bring a cursor into extreme left situation And, then again shift it to the left and hold before achievement of the necessary speed.
On cars with the diesel engine it is enough to wring out a cursor And to the left against the stop and to hold it before achievement of the necessary speed. At an otpuskaniye of a cursor there is a storing of speed.
ATTENTION
Blackout of system
Blackout of system is made by the shift of a cursor And against the stop to the right (the fixed position of AUS) or – at the motionless car – switching off of ignition.