1.13. Power windows and rear-view mirrors
At the included ignition of glass can fall and rise by means of the electric drive.Switches are located in an armrest of a door of the driver.
Besides, in a door of the forward passenger and back doors there are additional switches of management of the corresponding window regulators.
Window regulators work after switching off of ignition about ten minutes. However they are disconnected when opening one of forward doors at once.
The blocking switch (A) it is possible to cut off power window regulators of back doors.
From back doors window regulators can use only at the drowned switch.
At the disconnected window regulators of back doors in the blocking switch we burn a symbol.
Lifting / lowering of glasses
By short-term pressing of the switch of a window regulator flew down automatically and completely falls, and at a short-term pripodnimaniye rises to extreme situation. Repeated pressing of the switch it is possible to stop glass in any intermediate position.
Automatic equipment of lifting of glasses works only at the included ignition.
ATTENTION
For maintenance of window regulators after connection of the battery execute the following:
Continuous pressing the switch of a window regulator bring glass into extreme top situation.
Release the switch and again press, holding the switch approximately within one second at the closed window.
Automatic equipment is again brought into an operating mode.
Comfortable opening / closing
At unlocking / locking of the car from a door of the driver or the forward passenger of a window it is possible to open / close as follows:
Turn and hold a key in the provision of unlocking – windows open. At return of a key to a starting position opening process instantly stops.
Turn and hold a key in the provision of locking – windows are closed. At return of a key to a starting position closing process instantly stops.
Comfortable unlocking / locking works also from a remote radioupravleniya*. Address subsection Keys, body locks with uniform management and the security alarm system.
ATTENTION
Therefore:
– if necessary cut off power the blocking switch (address the above-stated illustration) window regulators of back doors;
– leaving the car, always take out the ignition key;
– at comfortable closing of the car you monitor raising of glasses; it is especially important when closing glasses by means of a remote radioupravleniya*.
Rotary steklo1)
Back glasses can open turn aside and be established in two fixed provisions.
Opening
Undertake the corresponding surface of the hinge and take away it in the direction specified by an arrow to the first fixed situation (address an illustration).
Wring out the hinge against the stop outside completely to open a window. In this situation the hinge adjoins to a rack.
Closing
Take away the hinge from a rack and pull it passing the first fixed situation inside. The hinge has to adjoin to a rack.
Rear-view mirrors
Before a start of motion correctly establish rear-view mirrors that the rearview was at any time provided.
Internal mirror
Manual blackout of a mirror
At the normal provision of a mirror the rychazhok from its lower party has to be turned forward.
This rychazhok it is possible to darken a mirror:
Rychazhok in forward situation – normal situation.
Rychazhok in back situation – the provision of blackout.
Automatic blackout *
Adjust the provision of a mirror a hand.
At the included ignition there is automatic blackout of an internal mirror depending on light stream falling on it (for example, light of headlights behind).
At inclusion of internal lighting or transfer of a backing the mirror comes back to a starting position (without blackout).
External mirrors
The note on use convex and aspherical * external mirrors
Convex and aspherical mirrors increase the sector of the review. However they I reduce the image of objects. Therefore such mirrors are only conditionally suitable for distance assessment to the vehicles moving behind.
Automatically darkened external mirrors *
External mirrors are darkened automatically together with an internal mirror.
At the included ignition there is automatic blackout of mirrors depending on light stream falling on them (for example, light of headlights behind).
At inclusion of illumination of salon or transfer of a backing of a mirror come back to a starting position (without blackout).
ATTENTION
Heating of mirrors *
The reflective surface of external mirrors is warmed at the included ignition depending on external temperature.
Regulation of provision of external mirrors
(only 2-door cars)
The multiposition switch (A) carries out switching of the electric drive to an external mirror of the driver / the forward passenger or folding zerkal1).
External mirrors with the electric drive are established only at the included ignition by pressing the large-format button C.
The reflective surface of a mirror is displaced when pressing the relevant party of the button with shooters.
In neutral situation
L mirror of the driver
R mirror of the forward passenger
D folding both external zerkal1)
1) Only for certain export modifications.
4-door cars
About neutral situation
L mirror of the driver
R mirror of the forward passenger
And folding of both external mirrors
It is recommended to put mirrors, for example, for their preservation at the parking or in narrow spaces.
The reflective surface of a mirror is established in the necessary situation by pressing the relevant party of the large-format button C with the arrows put on it.
ATTENTION