1.24. Switches and switches


1 lighting of devices


At the included ignition rotation of the corrugated handle (1) it is possible to regulate smoothly brightness of a background of the display of the control panel and average console.

The chosen brightness of a background of the display is regulated automatically, depending on a surrounding background.

Besides, at the turned-on light brightness of devices, the display and lighting of the average console can be regulated smoothly rotation of the corrugated handle (1).

2 regulator of a tilt angle of headlights


Rotation of the corrugated handle of the electric regulator of a tilt angle of headlights it is possible to change smoothly provisions of their optical axes, according to the actual loading of the car.

Thanks to it extent of dazzle of drivers of counter transport will not exceed inevitable level. At the same time the correct installation of headlights creates the most favorable conditions for visibility of the road for the driver.
The tilt angle of headlights is regulated only at the turned-on passing beam.

Noted provisions of the regulator approximately correspond to the following conditions of loading of the car:

0 in the car the driver and the forward passenger, a luggage carrier is empty
The I all places are taken, the luggage carrier is empty
The II all places are taken, the luggage carrier is loaded
III took a driver's seat, the luggage carrier is loaded

3 switch of light


O
lighting vyklyucheno1)

parking fires
passing or driving beam

Having pulled on itself the switch at its stay in the provision of parking passing or driving beam, it is possible to include fog lights or back foggy lamps.

Foggy devices burn only at the included ignition. During start of the engine and after switching off of ignition they automatically switch to parking light.

ATTENTION

After extraction of a key from the ignition lock at not turned off light and an open door of the driver the buzzer signal is distributed.



1) Day external lighting
In some export modifications at the included ignition passing beam of the lowered brightness burns.

General provisions

When using of the above described signaling and lighting devices observe standard requirements.

On cars with right-hand steering the arrangement of switches differs from cars with left-side steering. However symbols on switches correspond to car symbols with left-side steering.


ATTENTION

At inclusion of ignition of cars to xenon light there is an automatic control of a tilt angle of headlights according to loading.



Fog lights and foggy lamps *


Burn at inclusion of parking fires or passing beam.

At their inclusion the control lamp which is built in in the switch burns. At the included back foggy lamps separate switching off of fog lights is impossible.

Back foggy lamp


The back foggy lamp burns only at the turned-on passing or driving light, and on cars with fog lights – also at the included parking fires.

At inclusion of back foggy lamps also fog lights automatically join. At the same time in both switches control lamps light up.
ATTENTION

The system of electric equipment of cars with the traction coupling device * a factory complete set provides automatic shutdown of back foggy lamps of the car at operation of the trailer.



General provision
When using of the above described signaling and lighting devices observe standard requirements.

1 traction control system (ASR) * or electronic program of stabilization of stability (ESP) *


ASR/ESP joins automatically at start of the engine. In need of it it is possible to include and disconnect pressing of a key.
At the switched-off device the control lamp burns.

2 emergency light alarm system

At turning on of the alarm light system synchronously with it the control lamp in its switch blinks.

Besides, arrows of indexes of turn of the control panel blink.

The alarm system works also at the switched-off ignition.

At accident with disclosure of safety cushions the alarm light system turns on automatically.


1 heating of a seat of the driver *

At the included ignition it is possible to use an electrical heating of a pillow and a seatback.

Heating joins and is smoothly regulated by the corrugated handle.

For heating inclusion the corresponding corrugated handle is brought out of situation 0 and turns with installation in one of six possible temperature ranges. Along with a heating system also illumination of a digital marking of the corresponding corrugated handle joins.

2 heating of back glass

The electrical heating works only at the included ignition. Until it is included, in its switch the control lamp burns.
The electrical heating of back glass is switched off approximately in 10 minutes independently.

As soon as visibility through back glass is restored, its heating needs to be switched off. Having reduced an electric power expense, you will cut also fuel consumption.
ATTENTION

On cars with the antenna on back glass it are three top links of the conductor which therefore do not heat up.



3 heating of a seat of the forward passenger *

At the included ignition it is possible to use an electrical heating of a pillow and a seatback.
Heating joins and is smoothly regulated by the corrugated handle.

For heating inclusion the corresponding corrugated handle is brought out of situation 0 and turns with installation in one of six possible temperature ranges. Along with a heating system also illumination of a digital marking of the corresponding corrugated handle joins.
ATTENTION

Whenever possible you are not on seats on a lap and do not subject a seat surface point to strong influence different way not to damage heating elements.



Lever switch of indexes of turn, driving / passing beam


Switch index of turn

Indexes of turn work only at the included ignition.
For inclusion of the right indexes of turn – the lever up.
For inclusion of the left indexes of turn – the lever down.
At the included indexes of turn the control lamp synchronously blinks
After completion of turn indexes are switched off automatically.

Giving of a signal of change of a lane

The lever is wrung out up or down to a point of resistance and keeps in this situation – the control lamp synchronously has to blink.

Driving / passing beam

Driving beam – wring out the lever forward.
Passing beam – the lever in average situation.

Light signal

Delay the lever to a steering wheel to resistance point – the control lamp of driving beam lights up.

Inclusion of parking fires

Parking fires burn only at the switched-off ignition.
For inclusion of parking fires on the right – translate the lever up.
For inclusion of parking fires at the left – translate the lever down.

Xenon light

At inclusion of ignition and during the movement to the turned-on passing beam there is an automatic control of a tilt angle of headlights according to loading and the mode of the movement (for example, at dispersal, braking). Thanks to it extent of dazzle of drivers of counter transport will not exceed inevitable level.
At malfunction on the display of the control system of malfunctions of the car the alarm symbol lights up
ATTENTION

After extraction of a key from the ignition lock at not turned off light and an open door of the driver the warning signal of a buzzer is distributed.
When using of the above described signaling and lighting devices observe standard requirements.