13:33. Removal and installation of a cleaner of back glass

Cleaner of back glass
1 – cover
2 – nut, 15 N • m
3 – lever
4 – consolidation
5 – jet
6 – sealing ring		7 - electric motor
8 – nut, 8 N • m
9 – rubber ring
10 – remote element
11 – brush

REMOVAL

PERFORMANCE ORDER
1. Cast away upward a cover.
2. Turn off a nut –2–.
3. Cast away upward the lever and move sideways in different directions. Thus the lever is removed from an electric motor axis cone.
4. Turn off a nut and remove the lever.
5. Remove internal facing of a door of a back, at the same time address the subsection Removal and installation of facing of a door of a back.
6. Rasstykuyte the socket-1-also remove a hose –2 jets.
7. Turn off bolts of fastening and remove the electric motor (are specified by shooters) (a key 10 mm).

INSTALLATION

PERFORMANCE ORDER
1. Carefully insert the electric motor through an opening in back glass. At the same time you monitor the correct provision of consolidation, as shown in an illustration.
2. Fix the electric motor by the moment of 8 N • m.
3. Join the socket and put on a jet hose.
4. Establish internal facing of a door of a back, at the same time address the subsection Removal and installation of facing of a door of a back.
5. Put on the lever an axis so that the distance and made 25 mm. The distance is measured from the lower edge of glass to the lower edge of a brush.
6. Fix the lever by the moment of 15 N • m.
7. Cast away a cover back.