13:26. Removal, installation and coding of the radio receiver

Arrangement of elements and conducting of the radio equipment
1 – radio receiver
2 – loudspeaker of low frequency,
2 – Ohm / 20 W
3 – loudspeaker of average/high frequency, 2 Ohms / 20 W
4 – the loudspeaker is broadband, 2 Ohms / 20 W		5 - loudspeaker bass (subwoofer)
6 – CD changer
7 – the roof antenna with the amplifier of the antenna
8 – output BOSE amplifier. In a luggage carrier behind behind side facing

The special key used for removal of the radio receiver from the car

The radio receiver installed at the plant is equipped by the sliding holder allowing to remove and establish quickly it. The special sliding collar which is included in the package of sale or can be acquired separately is for this purpose necessary.
Two devices 3344 are necessary for removal of the radio receiver installed at the plant.

Serially the radio receiver is supplied with a code for protection against thefts. The code interferes with unauthorized turning on of the radio receiver if its food was interrupted. The termination of power supply of the radio receiver happens, for example, at its removal, disconnection from the rechargeable battery or at burn-out of a safety lock.

If the radio receiver is coded, it is necessary to find out a code before shutdown of the rechargeable battery or removal. The individual code is specified in the operation manual on the radio receiver. It is not necessary to store it in the car.

If the code is unknown, only HUNDRED AUDIS can turn on the radio receiver.

REMOVAL

PERFORMANCE ORDER
1. Switch off ignition.
2. Disconnect a negative cable (–) of the rechargeable battery at the switched-off ignition.
ATTENTION

Thereof information from electronic blocks of memory as, for example, a radio receiver code is erased. Without code the radio receiver can be switched on only by the manufacturer or HUNDRED AUDIS. Therefore get acquainted with materials of the subsection Input of a Code of the Radio Receiver.

3. Insert keys into vents for release (arrow) so that they were recorded. The inscription "Top L" specifies to the left up, "Top R" to the right up.
4. Take out the radio receiver from the dashboard for eyes.
ATTENTION

At the same time do not warp the radio receiver and respectively the tool for its release.

5. Take out shtekerny connections of the radio receiver and antenna. Rasstykuyte I will corrode giving of food. If the radio receiver is attached without use of serial shtekerny connections, mark a cable not to mix them at assembly.

INSTALLATION

PERFORMANCE ORDER
1. Take out both exhaust collars from the radio receiver.
2. Connect shtekerny connections from a reverse side of the radio receiver.
3. Press the radio receiver into dashboards so that lock springs were recorded.
4. Attach a cable of mass of the rechargeable battery.
ATTENTION

Make active high-rise automatic equipment of the power window, and also establish hours and enter a radio tape recorder code, address the subsection Input of a Code of the Radio Receiver.

5. Turn on the radio receiver and check its work. If the radio receiver is installed with application of the anticreeping coding, enter at first a confidential code.

Recommendations about independent installation of the radio receiver

– For the radio receiver which is not corresponding to the regular radio receiver of the car there is the corresponding cable adapter.
ATTENTION

If the cable adapter is not applied, pay attention to that close there was no uninsulated cable. Emergence of short circuit can lead to ignition of a cable.

– You watch that only the checked noise suppressing elements (having permission to application) were applied. On sale there are special elements allowed for application in AUDIS having the guide to installation.
– At accession of conducting of a signal of speed (at the radio receiver with the GALA function = adaptation of loudness of the radio receiver according to speed) surely you watch that he did not become isolated накоротко, otherwise in the car there can be functioning failures for example, control systems of the engine. Connection of a signal of speed to the radio receiver of the third-party manufacturer can also cause malfunctions.