13:11. Replacement of batteries of a key of remote control
REMOVAL
ATTENTION
At removal of batteries check whether polarity is specified on batteries. If polarity is not specified, mark position of the battery.
PERFORMANCE ORDER |
| 1. Insert the screw-driver into a gap between the block of the transmitter-1-and the main key –2–. |
2. Turn the screw-driver in the direction of an arrow and by that disconnect the transmitter block from a key. |
| 3. Release the transmitter block, having pressed side clamps (are specified by shooters). Remove the transmitter block. | | 4. Disconnect the top battery-1-by means of the screw-driver from holders –2–, as shown shooters. | | 5. Take out a contact plate –1–. At the same time turn it so that two direct edges adjoined to both clamps. The contact plate can also be removed by means of the screw-driver. | 6. Disconnect the lower battery by means of the screw-driver from holders. | |
INSTALLATION
ATTENTION At installation of batteries you watch polarity. Polarity (+/–) is specified on the battery and the case.
PERFORMANCE ORDER |
| 1. Insert the lower battery a-4-positive pole (+) down into the case-5-. The positive pole (+) is specified on the case. | 2. Put a contact plate –3– on the battery-4-and turn behind clamps. |
3. Put the battery a-2-positive pole (+) down on a contact plate and record. | 4. Put the transmitter-1-block on the case-2-and record.
ATTENTION The block of the transmitter is shown on an illustration turned. |
5. Insert the complete block of the transmitter into the main key –6– and record. ATTENTION
The key has the transponder of a variable code designated by the beaten-out letter W. |
| |