6.2.6. Removal and installation of the generator

Generator

1 – maple belt
2 – generator
3 – tension regulator
4 – bolts
5 – protective cover
6 – bolts
7 - bolts, 50 N of m
8 – bolts, 50 N of m
9 – holder
10 – tension device
11 – bolts, 45 N of m

Petrol engine

REMOVAL

PERFORMANCE ORDER
1. To disconnect a cable of mass of the rechargeable battery (–) at the switched-off ignition.
ATTENTION

Thus, the memories given in electronic blocks, such as, a radio receiver code are erased. Without code only his manufacturer, for example, the AUDI radio receiver HUNDRED AUDIS can turn on the radio receiver. Therefore read instructions in the subsection Removal and installation of the rechargeable battery.


2. Turn off bolts of fastening and uncover the engine. For this purpose remove traffic jams and turn off nuts (arrows on an illustration). On an illustration the engine of 1.6 l of AEN is shown.
3. Mark the direction of rotation of a maple belt. For this purpose put with chalk an arrow in the direction of rotation. Klinova a belt, looking from a belt, rotates clockwise.
4. Take off maple a belt, address the subsection Removal and installation of a ridge maple belt.
5. Turn off 3 bolts of fastening of a tension element of a maple belt.
6. Disconnect an electric wire –1 (plug 30/B+).
7. Disconnect a cable-3-collar.
8. Rasstykuyte the socket-2-for what press a wire clip.
9. Turn off bolts of fastening and remove the generator from the holder.
INSTALLATION
10. Before installation approximately on 1 mm hammer at the generator carving plugs of bolts of fastening, (In).
11. Install the generator on the holder and fix by the moment 25 N • m.
12. Fix electric wires by the moment of 15 N of m and join. Fix a cable collar by the moment of 15 N of m.
13. Fix by the moment 25 N of m a tension element of a maple belt.
14. Establish to the place of maple a belt, address a podazdel Removal and installation of a ridge maple belt.
15. Establish a cover of the engine and fix it by bolts.
16. Attach a cable of mass of the rechargeable battery.
ATTENTION

Make active high-rise automatic equipment of the power window, and also establish hours and enter a radio tape recorder code, address the subsection Removal and installation of the rechargeable battery.


Diesel engine
REMOVAL
17. To disconnect a cable of mass of the rechargeable battery (–) at the switched-off ignition.
ATTENTION

Thus, the memories given in electronic blocks, such as, a radio receiver code are erased. Without code only his manufacturer, for example, the AUDI radio receiver HUNDRED AUDIS can turn on the radio receiver. Therefore read instructions in the subsections Removal and installation of the rechargeable battery and Input of a code of the radio receiver.


18. Uncover the engine as follows (address an accompanying illustration):

– Take out a stopper –1–.
– Turn out nuts (arrow).
– Remove a bracket –2– from a finger –3– and uncover.
19. Remove a noise-attenuating element in the center and on the right.
20. Disconnect an electric wire –1 (plug 30/B+), address an illustration.
21. Disconnect a collar of fastening of a cable-3-.
22. Rasstykuyte the socket-2-for what press a wire clip.
23. Mark the direction of rotation of a maple belt. For this purpose put with chalk an arrow in the direction of rotation. Klinova a belt, looking from a belt, rotates clockwise.
24. Take off maple a belt, address the subsection Removal and installation of a maple belt.
25. Turn off 3 bolts of fastening of a tension element of a maple belt.
26. Conditioner: Turn off bolts of fastening (A) and remove the compressor and suspend on a body with the attached wires.
27. Cars with the strengthened cooling: Remove the additional fan on the right. Protect a radiator from damages by a cardboard.
28. All cars: Turn off bolts of fastening and remove the generator, take out it upward.
INSTALLATION
29. Before installation approximately on 1 mm hammer carving plugs of bolts of fastening at the generator, look also (In).
30. Install the generator on the holder and fix by the moment 25 N of m.
31. Cars with the strengthened cooling: Install the right additional fan, remove a cardboard.
32. Conditioner: Fix on the holder the compressor by the moment of 45 N of m.
33. Fix a natyazhitel of a belt by the moment 25 N of m.
34. Establish maple a belt, address the subsection Removal and installation of a maple belt.
35. Fix electric wires by the moment of 15 N of m and join them. Fix a cable collar by the moment of 15 N of m.
36. Establish a noise damper in the center and on the right.
37. Fix an engine cover, press traffic jams.
38. Attach a cable of mass of the rechargeable battery.
ATTENTION

Make active high-rise automatic equipment of the power window, and also establish hours and enter a radio tape recorder code, address the subsection Removal and installation of the rechargeable battery.