4.2.4. Removal and installation of the drive heater / replacement of a lamp

Lighting of the switch is carried out by the light guide, there is only one glow lamp. For replacement of a lamp remove the fan switch. Take out a lamp from the boss flat-nose pliers. Since the middle of 1997 of release replacement by a light-emitting diode (LED) is made. The last is not replaced.

REMOVAL

PERFORMANCE ORDER
1. Remove the radio receiver, address the subsection Removal, installation and coding of the radio receiver.
2. Remove an overlay of switches (A).
3. Unscrew 4 screws of fastening (V) of the control unit. At the same time pay attention to the provision of brackets (C) for the subsequent assembly.
4. Remove the forward central console (D), address the subsection Removal and installation of the lower central console.
5. Remove control unit cables, address the subsection Removal and installation of cables of the drive of management of a heater.
INSTALLATION
6. Fix cables on the control unit and adjust them, address the subsection Removal and installation of cables of the drive of management of a heater.
7. Install the forward central console, address subsection Fusible inserts.
8. Fix the heater drive to the central part of the dashboard by the moment of 5 N of m.
9. Establish an overlay of switches.
10. Install the radio receiver, address the subsection Removal, installation and coding of the radio receiver.