10:11. Removal and installation of the lever and cable of the parking brake
The lever of the parking brake with fastening elements
1 – lever of the parking brake Before removal remove the central console. 2 – lock washer 3 – facing of the lever of the parking brake. Acts forward 4 – nut, 25 N • m 5 - adapter. For cars with the central armrest 6 – draft | 7 - equalizer 8 – adjusting nut 9 – support finger 10 – cable of the parking brake 11 – switch of control of the parking brake |
REMOVAL OF THE CABLE
Cars with the forward drive
PERFORMANCE ORDER |
1. Remove the back central console, at the same time address the subsection Removal and installation of a pocket from the driver. | 2. Release the parking brake. | | 3. Turn off an adjusting nut so that the cable could be removed from the equalizer. Disconnect a cable of the parking brake. | 4. Disconnect a cable of the parking brake at a support, at the same time address the subsection Removal and installation of disk brake mechanisms of back wheels. | 5. Mark paint the provision of back wheels concerning naves. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel on the car standing on the earth. Lift a back part of the car, put it on supports and remove back wheels. | | 6. Disconnect a cable from the holder (A) at a beam of a back suspension bracket and remove from holders. |
| 7. Disconnect a cable from the holder (A) at a beam of a back suspension bracket and remove from holders | 8. Take out a cable. |
|
INSTALLATION