3.8.3. Dynamic control of pressure of oil
If in the course of the movement the signaling device of oil begins to blink and the buzzer sounds, the reasons can be the following:1. Too low level of oil
2. Malfunction in an electric part of the switch and a signaling device
3. The oil pump does not give oil
4. Damage of bearings of a bent shaft
At the same time first of all it is necessary to stop immediately the engine and to check oil level. If necessary it is necessary to add oil in system. After that it is necessary to start the engine on single turns. The signaling device has to go out. Lift speed over 1500 rpm. The signaling device should not blink, and the buzzer should not sound. If these conditions are satisfied, it is possible to move further.
If the level of oil is normal and there is no opportunity for further check, do not move further at all, and tow off the car and check oil pressure.
With a normal pressure of oil check the relay of pressure of oil and electric wires. In conditions HUNDRED it is possible to check in addition the monitor the engine for dashboards.