8.1. Adjustment of a cable of the selector of switching of automatic transmission

Driving cable of the selector of transfers of AT
1 – ignition switch
2 – blocking cable
3 – clamp
4 – selector lever handle
5 – adjusting screw
6 – cover
7 – protective cover
8 – protective tape slip
9 – selector lever
10 – nuts
11 – remote washer
12 – sealing laying
13 – selector lever casing
15 – nut		 16 – protective coupling
17 – nut
18 – selector lever cable
19 – sealant
20 – lock ring
21 – washer
22 – bolt
23 – transmission
24 – lever
25 – console
26 – washer
27 – the combined bolt
28 – the blocking element

PERFORMANCE ORDER
1. Install the selector in situation "P".
2. Turn off a bolt –2– at a forward support-1 of a cable of the selector.
3. Install the selector-4-in situation "P", having pressed it to a back emphasis. Blocking of the parking has to be recorded, at the released parking brake the car should not move.
ATTENTION

Do not remove a lock bracket.
4. Displace a selector cable at a bolt –2– so that it was not tense. In this situation tighten a bolt –2 moment of 5 N · m.
5. In conclusion check adjustment in a way described below.
Adjustment check
6. Transfer the selector to situation "P" at the pressed lock key in the handle approximately on 5 mm back and release. The selector has to return to a starting position independently.
7. Transfer the selector to situation "N" at the pressed lock key in the handle approximately on 5 mm forward and release. The selector has to return to a starting position independently.
8. If the selector is not fixed, repeat adjustment.
9. Pass on the car and check operation of the selector. The engine has to be started only in position of the selector "P" or "N".
10. Include ignition. At the standing car the selector has to have an opportunity to find only a way out "P" or "N" if the brake pedal is at the same time pressed.
Adjustment of a cable of blocking of switching
11. Install the selector in situation "1".
12. Uncover a steering column.
13. Turn the ignition key in situation "Start" and release. Check a gap between the lever of a cable and a lock finger of the lock. It has to make 0.7 mm.
14. For adjustment weaken a tightening nut of a cable and arrange the cable lever for achievement of the required gap.
15. Tighten a tightening nut.
16. Tighten bolts of the case of the switch and establish covers of a steering column.
Adjustment of an electromagnet of blocking of switching
17. Install the selector in situation "N" or "P".
18. Weaken bolts of fastening of an electromagnet.
19. Install the probe of 0.3 mm between a pusher of an electromagnet and the lever.
20. If it is required shift an electromagnet and tighten bolts of its fastening.